The difference between the electric valve and pneumatic valves

Views: 8     Author: Site Editor     Publish Time: 2016-10-21      Origin: Site

Electric gate valve is a kind of linear motion of the valve, it has to do with Z type rotary actuators are more suitable, had an "on/off" switch and intelligent.The valve operation simple is one of the most common opening and closing valve, which makes use of the upper and lower ram working fluid in the pipeline to switch on and off.Widely used in electric power, metallurgy, petroleum, chemical industry, paper making, sewage treatment and other departments.
Pneumatic valve pneumatic actuator is a double cylinder, and manual with buffering mechanism and its protection agency, the valve with double cylinder structure, its compared with single cylinder type pneumatic gate valve, the doubling of lifting force.This is fundamentally solved some of the single cylinder pneumatic valve body wedge die and won't open.
The difference between the electric valve and pneumatic valves
The difference between electric valves and pneumatic valves:
1 in the moment than electric valve, pneumatic valve, pneumatic valve switching speed can be adjusted, simple structure, easy maintenance, action for buffer characteristics of the gas itself in the process, not easy to damage due to get stuck, but must have a gas source, and its control system is more complicated than the electric valve.Pneumatic valve response is sensitive, safe and reliable, many factory of high control requirements for pneumatic instrumentation control components set the compressed air station.Pneumatic valve actuator power supply for gas source, gas source comes from air compressor, the locator converts electrical signals into the pneumatic control signal, drive the pneumatic actuators which can adjust the valve position.  
2, electric valve actuators are source of power for power supply, if the circuit board or motor failure prone to spark, so commonly used in the environmental requirements is not high and there is no danger of pneumatic actuators and electric actuators are adjustable performance comparison, pneumatic actuators response speed faster, more suitable for application in operating conditions, so the manufacturer of the regulator are produced at the same time a set with pneumatic actuators.  
3, the regulation of electric actuators response fast enough, the regulating valve with pneumatic actuator than electric actuator applications.  
4 pneumatic valves, electric valves and the essence of the difference between using a different drive, actuators, and regulating valve itself.Cooperate with different working condition of actuators is mainly, such as chemical and other occasions with explosion-proof requirements, is the most used pneumatic valve, because of the high security requirements, and the price is cheap, with intelligent positioner on can bus, control method is also simple.
That is about the difference between the electric valve and pneumatic valve related introduction, hope can help to you.

  • Q Are you a manufacturer or a trader?

    We have our own foundry ,forging factory and machinery shop located in Liaoning Province, China.
  • Q What can you do for customer?

    One Stop Service
    1).Manufacturing and supply various machinery parts.
    2). Technical analysis and design 
    3).Factory audit, on-site production supervision, in-time feedback, pre-shipment quality inspection
  • Q How could you commit the product quality?

    1) all our factories were ISO certified. 
    2) more than 50% of New Densen’s products were sold to worldwide top 500 companies 
    which located in North American, Western Europe, and Japan.
    3) New Densen’s QC engineers will do on-site supervision and before EX-work quality inspection. New Densen will issue inspection reports for customers’ approval before EX-work. New Densen will be responsible for its reports and every parts no matter how long sold to customers.
  • Q How long shall we get the quotation?

    Processing time for inquiry: 1-3 working days.
  • Q What's the process of developing a new steel casting product?

    The procedure for new project develop as below:
    1. Technical department analyze the drawings all details 
    2.Pattern design and manufacture
    3.Casting Process
    4.Quality Control inspect the casting parts
    5.Issue inspection report for customer to check quality
    6. After inspection report approved, Logistics Department help arrange the shipping to customer