Views: 0 Author: Site Editor Publish Time: 2016-11-16 Origin: Site
Stainless steel ball valve when installation should be strictly carried out in accordance with the installation requirements on the product manual, here are the stainless steel ball valve when installation should pay attention to the details to do the following:
1. Under the conditions of stainless steel ball valve fully open to rinse;
2. Stainless steel ball valve and pipeline connection, shall use the prescribed torque cross locking flange bolts;
3. The stainless steel flanged ball valves before and pipeline connection, must be clean pipeline residual impurities;
4. During the installation, do not use ball valve actuator part as a lifting of the lifting point, to avoid damaging actuators and accessories;
5. Cast steel flanged ball valves should be installed in horizontal or vertical direction;
Near 6. Cast steel ball valve installation of pipe cannot endure with low or the phenomenon of external force, can use a pipe support or support to eliminate line deviation;
7. Before install ball valve should be in accordance with the provisions of signal should be on the test, after qualified to install.
That is about the stainless steel ball valve installation details related introduction, hope can help to you.
Q Are you a manufacturer or a trader?
A
We have our own foundry ,forging factory and machinery shop located in Liaoning Province, China.
Q What can you do for customer?
A
One Stop Service
1).Manufacturing and supply various machinery parts.
2). Technical analysis and design
3).Factory audit, on-site production supervision, in-time feedback, pre-shipment quality inspection
Q How could you commit the product quality?
A
1) all our factories were ISO certified.
2) more than 50% of New Densen’s products were sold to worldwide top 500 companies
which located in North American, Western Europe, and Japan.
3) New Densen’s QC engineers will do on-site supervision and before EX-work quality inspection. New Densen will issue inspection reports for customers’ approval before EX-work. New Densen will be responsible for its reports and every parts no matter how long sold to customers.
Q How long shall we get the quotation?
A
Processing time for inquiry: 1-3 working days.
Q What's the process of developing a new steel casting product?
A
The procedure for new project develop as below:
1. Technical department analyze the drawings all details
2.Pattern design and manufacture
3.Casting Process
4.Quality Control inspect the casting parts
5.Issue inspection report for customer to check quality
6. After inspection report approved, Logistics Department help arrange the shipping to customer
English
