Stainless steel ball valve installation details
Publish Time: 2016-11-16 Origin: Site
Stainless steel ball valve when installation should be strictly carried out in accordance with the installation requirements on the product manual, here are the stainless steel ball valve when installation should pay attention to the details to do the following:
1. Under the conditions of stainless steel ball valve fully open to rinse;
2. Stainless steel ball valve and pipeline connection, shall use the prescribed torque cross locking flange bolts;
3. The stainless steel flanged ball valves before and pipeline connection, must be clean pipeline residual impurities;
4. During the installation, do not use ball valve actuator part as a lifting of the lifting point, to avoid damaging actuators and accessories;
5. Cast steel flanged ball valves should be installed in horizontal or vertical direction;
Near 6. Cast steel ball valve installation of pipe cannot endure with low or the phenomenon of external force, can use a pipe support or support to eliminate line deviation;
7. Before install ball valve should be in accordance with the provisions of signal should be on the test, after qualified to install.
That is about the stainless steel ball valve installation details related introduction, hope can help to you.